iRobot Robot mop Braava jet m6 Error 44
What this problem usually means
Mop-specific — Pump issue. See the app for help: the pump motor did not start up when trying to wet mop — there is an issue with the pump activating at the start of a cleaning job, and the robot is not dispensing water.
Likely causes
- Tank not installed properly or the lid not closed
- No wet pad installed, or the tank not full
- Debris on the spray nozzle
- Debris in the filter in the tank well
How to fix it — step by step
- Check the tank is installed properly and the lid is closed
- Fit a wet pad and fill the tank with water, or water mixed with 6 caps of iRobot Hard Floor Cleaning Solution
- Check the nozzle is free of debris — wipe any debris away with a lightly dampened melamine foam such as a Magic Eraser
- Check the filter in the tank well is free of debris — if debris is found, remove the tank and filter and rinse with warm water
- Contact iRobot Customer Care if the issue persists after all steps
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official iRobot manual is on iRobot's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.