iRobot Robot mop Braava jet m6 Error 18

What this problem usually means

Docking problem. Place on the Home Base to charge: the m Series chart says the robot is stuck in the Home Base IR after undocking; iRobot's dedicated article describes the same code as the robot being unable to return to the Home Base or starting position.

Likely causes

  1. Home Base unplugged, moved or rotated during the cleaning cycle
  2. Charging contacts on the robot or Home Base dirty with residue or debris
  3. Infrared interference from a Virtual Wall barrier or another Home Base within about 8 ft (2.5 m)
  4. Wheels obstructed so the robot cannot dock

How to fix it — step by step

  1. Make sure the Home Base did not get unplugged, moved or rotated during the job, and that it sits on a hard, level surface against a wall with a clear path to it
  2. Wipe the charging contacts on both the Home Base and the robot clean with a clean dry cloth
  3. Check the wheels for obstructions
  4. Place the robot on the Home Base to charge, and move the Home Base to a different location and start from the Home Base if the message persists

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official iRobot manual is on iRobot's support site — you'll need your model number.

Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.

Related iRobot Robot mop Braava jet m6 problems

See all iRobot Braava jet m6 codes & guides →