iRobot Robot mop Braava jet m6 Error 19
What this problem usually means
Undocking problem. Clear obstacles, and then press Clean: the robot failed to undock from the Home Base and may have bumped something near it.
Likely causes
- Obstacle near the Home Base that the robot bumped while undocking
- Virtual Wall within 8 ft (2.4 m) of the Home Base, or another Home Base within 3 ft (1 m)
How to fix it — step by step
- Clear obstacles in front of and around the Home Base
- Make sure there is no Virtual Wall within 8 ft (2.4 m) of the Home Base and no additional Home Base within 3 ft (1 m) of it
- Reboot the robot (hold the CLEAN button for roughly 20 seconds) to clear the error
- Press CLEAN to retry, and move the Home Base to a different location and start from the Home Base if the message persists
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official iRobot manual is on iRobot's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.