iRobot Robot mop Braava jet 240 2-tone distress sound + 3 beeps

What it should sound like on your machine

then it repeats

3 beeps - then the pattern repeats. Count along with your machine and compare.

What this problem usually means

"Uh Oh" + three beeps: no pad is installed, or the pad fell off during the cleaning cycle.

Likely causes

  1. No cleaning pad installed
  2. Pad fell off during the cycle, e.g. on an obstacle
  3. Non-authentic pad, or a wet pad detection sensor at startup

How to fix it — step by step

  1. Fit an authentic Braava jet cleaning pad and make sure it is properly installed — try turning the pad around and installing it in the other direction → Shop the cleaning pad at Amazon
  2. If it happens at startup, remove the pad and dry the underside of the robot, including the pad detection sensor, with a clean melamine foam such as a Magic Eraser
  3. If the pad falls off on an obstacle, use Virtual Wall Mode or a physical barrier to block off the problem area
  4. Make sure Braava jet has the latest software version
  5. Replace the pad if the problem persists, and contact iRobot Customer Care if it persists after pad replacement

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official iRobot manual is on iRobot's support site — you'll need your model number.

Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.

Related iRobot Robot mop Braava jet 240 problems

See all iRobot Braava jet 240 codes & guides →