iRobot Robot mop Braava jet 240 2-tone distress sound + 2 beeps

What it should sound like on your machine

then it repeats

2 beeps - then the pattern repeats. Count along with your machine and compare.

What this problem usually means

"Uh Oh" + two beeps: the bumper is being pressed in when trying to start a cycle.

Likely causes

  1. Bumper held in or obstructed at startup
  2. Clear plastic shipping film still on the top and sides of the robot
  3. Debris holding the bumper in

How to fix it — step by step

  1. Check the bumper for obstructions
  2. Make sure the clear plastic film has been removed from the top and sides of the robot
  3. Do not hold the bumper in when starting a cleaning cycle
  4. Tap the bumper to clear it if the message persists
  5. Contact iRobot Customer Care if the message still persists

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official iRobot manual is on iRobot's support site — you'll need your model number.

Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.

Related iRobot Robot mop Braava jet 240 problems

See all iRobot Braava jet 240 codes & guides →