iRobot Robot mop Braava jet 240 2-tone distress sound + 1 beep

What it should sound like on your machine

then it repeats

1 beep - then the pattern repeats. Count along with your machine and compare.

What this problem usually means

"Uh Oh" + one beep: Braava jet is stuck over an edge, is on a threshold or grate, or is on a dark surface. iRobot documents these beep codes for Braava jet (the jet 200 series, including the 240) in its 2-tone error messages chart.

Likely causes

  1. Robot stuck over an edge, threshold or grate
  2. Dark surface being read as an edge by the cliff sensors
  3. Dirty cliff sensors

How to fix it — step by step

  1. Move Braava jet to a new location and press CLEAN to start a new cleaning cycle
  2. Use Virtual Wall Mode to keep Braava jet away from problem areas if it repeats
  3. Make sure you have a full tank, a fresh pad and a fully charged battery
  4. Wipe the cliff sensors with a clean melamine foam
  5. Make sure Braava jet has the latest software

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official iRobot manual is on iRobot's support site — you'll need your model number.

Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.

Related iRobot Robot mop Braava jet 240 problems

See all iRobot Braava jet 240 codes & guides →