GMC Truck Sierra 1500 Vibration and clunking from driveshaft
What this problem usually means
On 2019-2020 Sierra 1500s a weld on the driveshaft joint may not have been made properly at the factory and can come apart, causing a new vibration or clunk from under the truck, then a sudden loss of drive power, possibly with damage underneath. GM recalled affected trucks.
Likely causes
- Incorrectly made factory weld on the driveshaft joint
- Driveshaft separation causing loss of drive power
How to fix it — step by step
- Run the VIN through NHTSA's recall lookup for the driveshaft recall
- If a new driveline vibration starts, slow down and have it inspected before driving further
- Have the rear driveshaft inspected on a lift → Shop the rear driveshaft at Amazon
- Recall replacement of the rear driveshaft is performed free by a dealer for affected trucks
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the rear driveshaft.
Parts that commonly fix it
- rear driveshaft - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.
Related GMC Truck Sierra 1500 problems
- A/C not blowing cold
- Blower motor only works on high
- Engine stalls and won't restart
- Fuel pump failure causing long cranking and stalling
- Grinding hum from front wheel and ABS light on
- Hard brake pedal
- Harsh shifting on diesel 10-speed
- Lifter ticking noise
- Rusted brake lines leaking
- Transmission slipping
- Truck pulls to one side and brakes on its own