GMC Truck Sierra 1500 Grinding hum from front wheel and ABS light on
What this problem usually means
On 1999-2006 Sierra 1500s the front ABS speed sensors are built into the wheel hub assemblies, and they corrode or fail with the bearings. Symptoms are ABS and brake warning lights on together, the ABS kicking in at low speed, or a grinding hum from a front wheel. Normal braking works, but ABS will not until it is fixed.
Likely causes
- Corroded or failed front wheel hub bearing assembly
- Failed ABS speed sensor built into the hub
How to fix it — step by step
- Have the ABS codes read to find which wheel is at fault
- Jack up the front end safely and check the suspect hub for play and grinding
- Replace the front wheel hub bearing assembly on the affected side → Shop the front wheel hub bearing assembly at Amazon
- Clear codes and test that the ABS light stays off
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the front wheel hub bearing assembly.
Parts that commonly fix it
- front wheel hub bearing assembly - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.
Related GMC Truck Sierra 1500 problems
- Hard brake pedal
- Harsh shifting on diesel 10-speed
- Lifter ticking noise
- Rusted brake lines leaking
- Transmission slipping
- Truck pulls to one side and brakes on its own
- Vibration and clunking from driveshaft
- A/C not blowing cold
- Blower motor only works on high
- Engine stalls and won't restart
- Fuel pump failure causing long cranking and stalling