GMC Truck Sierra 1500 Truck pulls to one side and brakes on its own
What this problem usually means
On 2014-2018 Sierra 1500s (5.3L V8, 4WD), if a wheel speed sensor fails, the stability system can wrongly apply the brake at one wheel, so the truck pulls hard to one side or slows unexpectedly, often with ABS or stability warning lights. GM recalled affected trucks for a software fix.
Likely causes
- Failed wheel speed sensor feeding wrong data to the stability system
- Stability system applying one wheel's brake in error
How to fix it — step by step
- If the truck pulls or brakes by itself, pull over safely
- Run the VIN through NHTSA's recall lookup and have the GM software recall completed
- Have the wheel speed sensors tested and replace a failed sensor → Shop the wheel speed sensor at Amazon
- Do not resume regular driving until the recall and sensor check are done
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the wheel speed sensor.
Parts that commonly fix it
- wheel speed sensor - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.
Related GMC Truck Sierra 1500 problems
- Vibration and clunking from driveshaft
- A/C not blowing cold
- Blower motor only works on high
- Engine stalls and won't restart
- Fuel pump failure causing long cranking and stalling
- Grinding hum from front wheel and ABS light on
- Hard brake pedal
- Harsh shifting on diesel 10-speed
- Lifter ticking noise
- Rusted brake lines leaking
- Transmission slipping