GE Washer Front-Load E4B Error Code
What the E4B code means
Inverter power-up fault on GE front-load washers: a software/hardware problem occurred when the inverter powered up.
Likely causes
- Inverter control board hardware failure → Shop the inverter control board at RepairClinic
- Control software glitch at power-up
- Power surge or unstable supply
How to fix it — step by step
- Turn off power at the breaker or unplug for 5 minutes
- Restore power and start a short cycle
- If the code comes straight back, the inverter/control hardware needs service
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the inverter control board.
Parts that commonly fix the E4B code
- inverter control board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official GE manual is on GE's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.