GE Washer Front-Load E4C Error Code
What the E4C code means
Inverter over-voltage on GE front-load washers: the DC bus voltage in the inverter is too high.
Likely causes
- High or unstable household supply voltage
- Failing inverter control board → Shop the inverter control board at RepairClinic
- Power surge
How to fix it — step by step
- Unplug the washer for 5 minutes and plug it directly into a wall outlet
- Try one short cycle after restoring power
- If E4C repeats, stop - supply voltage and the inverter board need professional checking
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the inverter control board.
Parts that commonly fix the E4C code
- inverter control board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official GE manual is on GE's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.