GE Washer Front-Load E4E Error Code
What the E4E code means
Inverter under-voltage after start on GE front-load washers: the minimum voltage was not received after starting, so the motor does not run.
Likely causes
- Supply voltage dropping under load
- Loose inverter or motor wiring
- Failing inverter control board → Shop the inverter control board at RepairClinic
How to fix it — step by step
- Unplug for 5 minutes, then retry once on a direct wall outlet
- Make sure no other large appliance is sharing the circuit
- If the motor still does not run, arrange service
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the inverter control board.
Parts that commonly fix the E4E code
- inverter control board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official GE manual is on GE's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.