GE Washer Front-Load E47 Error Code
What the E47 code means
Heat sink / inverter over-temperature on GE front-load washers: the inverter control board's heat sink overheated.
Likely causes
- Drive motor overworking and overheating the inverter → Shop the drive motor at RepairClinic
- Loose wiring connections to the drive motor
- Failing drive motor
- Failed inverter control board → Shop the inverter control board at RepairClinic
How to fix it — step by step
- Unplug the washer and let it cool for at least 30 minutes
- Retry once with a smaller load
- If the code returns, stop using the washer until serviced
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the drive motor.
Shop the drive motor at RepairClinic or Amazon
Also tied to this fault: inverter control board - Shop at RepairClinic or Amazon
Parts that commonly fix the E47 code
- drive motor - Shop at RepairClinic or Amazon
- inverter control board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official GE manual is on GE's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.