Ford SUV Bronco Manual transmission scraping noise
What this problem usually means
On 2021-2023 Broncos with the seven-speed manual, a scraping noise in neutral, first, or second gear is the subject of a Ford service bulletin. Drivers should also check for clean engagement of the crawler gear and reverse.
Likely causes
- manual transmission internal wear covered by a ford service bulletin
How to fix it — step by step
- Note whether the scraping occurs in neutral, first, and second gear
- Check that the crawler gear and reverse engage cleanly
- Ask a dealer to check whether the Ford service bulletin applies to your Bronco
- Have the transmission inspected internally if the noise persists
- Road-test through every gear and confirm the scraping is gone
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
No specific replacement part is documented for this fault. If the checks above do not clear it, the machine likely needs to be disassembled and an internal part replaced - and since the manufacturer publishes no procedure for that, it is the point where most owners hand it to a repair shop.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Ford manual is on Ford's support site — you'll need your model number.
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.