Ford SUV Bronco Loose front suspension fasteners
What this problem usually means
Some 2024-2025 Broncos were recalled because an upper ball-joint nut or lower control-arm bolt can be loose or missing, in some cases with no warning before the arm separates. Symptoms can be a front-end clunk or nothing at all, and for some campaigns Ford told owners not to drive until repaired.
Likely causes
- loose or missing upper ball-joint nut
- loose lower control-arm fasteners
How to fix it — step by step
- Check by VIN whether the recall applies to your Bronco, and do not drive it if the recall says so
- Listen for a clunk from the front end over bumps
- Have a dealer inspect and tighten or replace the fasteners, ball joint, and knuckle as the recall directs → Shop the knuckle at Amazon
- Torque-check the upper ball-joint nuts and lower control-arm bolts after any suspension work → Shop the upper ball joint at Amazon
- Confirm there is no clunk and the steering feels secure on a road test
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the upper ball joint.
Shop the upper ball joint at Amazon
Also tied to this fault: knuckle - Shop at Amazon
Parts that commonly fix it
- upper ball joint - Shop at Amazon
- knuckle - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Ford manual is on Ford's support site — you'll need your model number.
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.