Ecovacs Robot vacuum Deebot X2 DEEBOT does not respond to the Station instruction
What this problem usually means
The robot ignores commands from the OMNI Station.
Likely causes
- DEEBOT is not in the Station
How to fix it — step by step
- Make sure DEEBOT is in the Station
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.
Related Ecovacs Robot vacuum Deebot X2 problems
- DEEBOT gets stuck while working and stops
- DEEBOT is not able to connect to ECOVACS HOME App
- DEEBOT is unable to charge
- DEEBOT returns to the Station before it has finished cleaning
- DEEBOT Side Brush drops out of place during use
- Delay in remote control
- Disordered cleaning route, deviation from the cleaning route, repeated cleaning, or missing of small areas
- Driving wheels are blocked
- Dust leakage occurs during working
- Fail to empty the Dust Bin
- Mopping Pad Plate cannot rotate
- No signal found. Unable to return to the Station