Ecovacs Robot vacuum Deebot X2 DEEBOT is unable to charge
What this problem usually means
The robot is at the OMNI Station but not charging.
Likely causes
- DEEBOT is not switched ON
- DEEBOT's Charging Contacts are not connected to the Station Pins, or the contacts/Pins are dirty
- The Station is not connected to the power supply
How to fix it — step by step
- Switch ON DEEBOT
- Make sure the robot's Charging Contacts have connected to the Station Pins; check whether the Charging Contacts and Station Pins are dirty and clean them as described in the Maintenance section (the X2 manual also advises wiping Charging Contacts with a clean dry cloth if DEEBOT fails to charge)
- Make sure the Station is connected to the power
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.
Related Ecovacs Robot vacuum Deebot X2 problems
- DEEBOT returns to the Station before it has finished cleaning
- DEEBOT Side Brush drops out of place during use
- Delay in remote control
- Disordered cleaning route, deviation from the cleaning route, repeated cleaning, or missing of small areas
- Driving wheels are blocked
- Dust leakage occurs during working
- Fail to empty the Dust Bin
- Mopping Pad Plate cannot rotate
- No signal found. Unable to return to the Station
- Running is very loud during cleaning
- The map is lost
- Unable to create furniture map on App