Ecovacs Robot vacuum Deebot X2 DEEBOT is not able to connect to ECOVACS HOME App
What this problem usually means
App setup fails and the robot cannot be paired with the ECOVACS HOME App.
Likely causes
- Incorrect home Wi-Fi username or password entered
- DEEBOT is not within range of your home Wi-Fi signal
- DEEBOT is not in the configuration state
- Incorrect App installed
- Not using a 2.4GHz or 2.4/5 GHz mixed network (5 GHz is not supported)
How to fix it — step by step
- Enter the correct home Wi-Fi username and password
- Make sure DEEBOT is within range of your home Wi-Fi signal
- Make sure DEEBOT is connected to the power supply and turned ON, open the cover and press the RESET Button; DEEBOT enters the configuration state when you hear a voice prompt
- Download and install the ECOVACS HOME App
- Use a 2.4GHz or 2.4/5 GHz mixed network
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.
Related Ecovacs Robot vacuum Deebot X2 problems
- DEEBOT is unable to charge
- DEEBOT returns to the Station before it has finished cleaning
- DEEBOT Side Brush drops out of place during use
- Delay in remote control
- Disordered cleaning route, deviation from the cleaning route, repeated cleaning, or missing of small areas
- Driving wheels are blocked
- Dust leakage occurs during working
- Fail to empty the Dust Bin
- Mopping Pad Plate cannot rotate
- No signal found. Unable to return to the Station
- Running is very loud during cleaning
- The map is lost