Ecovacs Robot vacuum Deebot T20 DEEBOT is not able to connect to ECOVACS HOME App

What this problem usually means

App setup fails and the robot cannot be paired with the ECOVACS HOME App.

Likely causes

  1. Incorrect home Wi-Fi username or password entered
  2. DEEBOT is not within range of your home Wi-Fi signal
  3. DEEBOT is not in the configuration state
  4. Incorrect App installed
  5. Not using a 2.4GHz or 2.4/5 GHz mixed network (5 GHz is not supported)

How to fix it — step by step

  1. Enter the correct home Wi-Fi username and password
  2. Make sure DEEBOT is within range of your home Wi-Fi signal
  3. Make sure DEEBOT is connected to the power supply and turned ON, open the cover and press the RESET Button; DEEBOT enters the configuration state when you hear a voice prompt
  4. Download and install the ECOVACS HOME App
  5. Use a 2.4GHz or 2.4/5 GHz mixed network

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.

Related Ecovacs Robot vacuum Deebot T20 problems

See all Ecovacs Deebot T20 codes & guides →