Ecovacs Robot vacuum Deebot T20 Voice prompt: the Cleaning Sink is full
What this problem usually means
When the water in the Cleaning Sink is full and cannot be drained out, the voice reports that the Cleaning Sink is full.
Likely causes
- The Dirty Water Tank is not properly installed
- The sealing plugs in the Dirty Water Tank are not installed properly
- The Station cannot drain water normally
- The suction port of the Cleaning Sink is blocked by a foreign object
- The voice prompt still exists after trying the manual's solutions
How to fix it — step by step
- Tap down on the Dirty Water Tank to ensure it is properly installed
- Check that the sealing plugs in the Dirty Water Tank are properly installed
- Use the station's press-and-hold drain/self-clean procedure to see whether the Station can properly draw the water; if it can, wipe dry the Water Overflow Sensor of the Cleaning Sink
- If the Station fails to draw the water, check between the Dirty Water Tank and the Station for a foreign object and clean it
- Ensure there is no foreign object in the suction port of the Cleaning Sink
- Unplug the Station and plug it in again; if the problem persists, contact ECOVACS Customer Care
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
No specific replacement part is documented for this fault. If the checks above do not clear it, the machine likely needs to be disassembled and an internal part replaced - and since the manufacturer publishes no procedure for that, it is the point where most owners hand it to a repair shop.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.
Related Ecovacs Robot vacuum Deebot T20 problems
- Ash leakage occurs during working (dust leakage)
- DEEBOT does not respond to the Station instruction
- DEEBOT gets stuck while working and stops
- DEEBOT is not able to connect to ECOVACS HOME App
- DEEBOT is not charging
- DEEBOT returns to the Station before it has finished cleaning
- Driving wheels are blocked
- During cleaning, DEEBOT appears in route disorder, running bias, repeated cleaning, small area leakage
- Fail to enable Child Lock
- Mopping Pad Plates cannot rotate
- No signal found. Unable to return to the Station
- The inner side of Dust Collection Cabin is dirty