Dreame Robot vacuum Dreame X30 Ultra The robot fails to connect to Wi-Fi

What this problem usually means

The robot cannot join the home Wi-Fi network during app setup.

Likely causes

  1. Wi-Fi network password is incorrect
  2. A 5 GHz Wi-Fi connection was used (not supported)
  3. Wi-Fi signal is weak
  4. The robot is not ready to be configured

How to fix it — step by step

  1. Make sure the password used to connect to your Wi-Fi network is correct
  2. Connect the robot to a 2.4 GHz Wi-Fi connection instead of 5 GHz
  3. Make sure the robot is in an area with good Wi-Fi coverage
  4. Exit and re-enter the app, then try again as instructed

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.

Related Dreame Robot vacuum Dreame X30 Ultra problems

See all Dreame Dreame X30 Ultra codes & guides →