Dreame Robot vacuum Dreame X30 Ultra The water level in the washboard is abnormal
What this problem usually means
The base station washboard (mop-washing tray) holds an abnormal water level during mop washing.
Likely causes
- The seal on the used water tank is loose or not correctly installed
- The used water tank is not installed correctly
- The sewage drain under the washboard is blocked
- A liquid other than the officially-approved cleaning solution was added
How to fix it — step by step
- Check whether the seal on the used water tank is loose or not correctly installed, and manually reset it if so
- Gently press down on the used water tank to make sure it is installed correctly
- Remove the washboard and check whether the sewage drain is blocked, and clean it
- Check the cleaning solution; do not add any liquid other than the officially-approved cleaning solution
- If the problem persists, contact the after-sales service team
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.
Related Dreame Robot vacuum Dreame X30 Ultra problems
- The charging speed is slow
- The mop pad holder is raised abnormally
- The noise increases while the robot is operating
- The robot cannot find and return to the base station
- The robot fails to connect to Wi-Fi
- The robot gets stuck in front of the base station and cannot return to it
- The robot misses the rooms to be cleaned
- The robot moves without following the set route
- The robot will not charge
- The robot will not resume cleaning after charging
- The robot will not turn off
- The robot will not turn on