Whirlpool Washer Duet (Legacy Front-Load) FH Error Code
What the FH code means
Water inlet problem: no water is detected entering the machine, or the pressure switch trip was not detected.
Likely causes
- Water faucets not turned on fully
- Plugged or kinked inlet hoses
- Clogged inlet valve screens → Shop the water inlet valve at RepairClinic
- Failed water inlet valve
- Pressure switch hose or drain pump problem if water is present → Shop the pressure switch at RepairClinic
How to fix it — step by step
- Press Pause/Cancel twice to clear the code
- Unplug the washer and check both faucets are fully on
- Check inlet hoses for kinks and clean the inlet screens
- Plug in, reselect the cycle and press Hold to Start
- If water is in the tub but the code returns, call for service
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the water inlet valve.
Shop the water inlet valve at RepairClinic or Amazon
Also tied to this fault: pressure switch - Shop at RepairClinic or Amazon
Parts that commonly fix the FH code
- water inlet valve - Shop at RepairClinic or Amazon
- pressure switch - Shop at RepairClinic or Amazon
Before you buy: check the water inlet valve first
Test: Unplug the washer and measure each fill valve solenoid's coil resistance at the valve or at the ACU connector pins listed in the tech sheet.
A good one reads: 1100–1350 Ω per coil (Whirlpool tech sheet W11417646, Test #6). Older Duet solenoids spec 800 Ω — use the range on your model's tech sheet; open or far out of range means replace the valve assembly.
Test values from forum.appliancepartspros.com documentation - confirm against your model's own tech sheet.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Whirlpool manual is on Whirlpool's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.