Whirlpool Washer Duet (Legacy Front-Load) F02 Error Code
What the F02 code means
Long drain / drain problem on older Duet models: draining takes longer than 8 minutes.
Likely causes
- Drain hose kinked, frozen or clogged
- Drain hose more than 96 inches above the floor
- Clogged pump filter
- Failed drain pump
How to fix it — step by step
- Press Pause/Cancel twice to cancel the cycle and unplug the washer
- Check the drain hose is not kinked, frozen or clogged
- Check the hose is no more than 96 inches above the floor
- Clean the drain pump filter if accessible → Shop the drain pump at RepairClinic
- Restore power, reselect the cycle and press Hold to Start
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the drain pump.
Parts that commonly fix the F02 code
- drain pump - Shop at RepairClinic or Amazon
Before you buy: check the drain pump first
Test: Unplug the washer, disconnect the wire connector at the pump, set the meter to the R×1 scale, and measure across the pump terminals.
A good one reads: Approximately 12.3 Ω (Whirlpool CHW9050 service manual). The value is generation-specific: Duet-era tech sheets spec 15 Ω and current Whirlpool tech sheet W11417646 specs 18.5–21.5 Ω, so confirm against your model's tech sheet.
Test values from manualslib.com documentation - confirm against your model's own tech sheet.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Whirlpool manual is on Whirlpool's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.