Whirlpool Washer Duet (Legacy Front-Load) F05 Error Code
What the F05 code means
Water temperature sensor error on older Duet models: the sensor value is out of range during the heating step.
Likely causes
- Failed water temperature sensor (NTC) → Shop the temperature sensor at RepairClinic
- Heating element circuit failure
- Loose connections to the sensor or heater
How to fix it — step by step
- Unplug the washer and disconnect power
- Restart a cycle after restoring power to see if the code returns
- If it returns, call for service to test the sensor and heating element → Shop the heating element at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the temperature sensor.
Shop the temperature sensor at RepairClinic or Amazon
Also tied to this fault: heating element - Shop at RepairClinic or Amazon
Parts that commonly fix the F05 code
- temperature sensor - Shop at RepairClinic or Amazon
- heating element - Shop at RepairClinic or Amazon
Before you buy: check the temperature sensor first
Test: Disconnect the temperature sensor and measure its resistance, comparing it to the temperature where the sensor sits.
A good one reads: 35.9 kΩ at 32°F (0°C) and 9.7 kΩ at 86°F (30°C) (Whirlpool Duet component testing table, Job Aid 8178076). Resistance should fall smoothly as temperature rises.
Test values from idoc.pub documentation - confirm against your model's own tech sheet.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Whirlpool manual is on Whirlpool's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.