Whirlpool Washer Duet (Legacy Front-Load) F06 Error Code
What the F06 code means
Drive motor tachometer error on older Duet models: the control is unable to detect motor speed.
Likely causes
- Loose harness between drive motor and motor control unit → Shop the drive motor at RepairClinic
- Loose harness between motor control and central control
- Failed drive motor or motor control unit
How to fix it — step by step
- Unplug the washer for 5 minutes and restore power
- Retry with a smaller load; note the door unlocks after 3 minutes if this happens in high-speed spin
- If the code returns, call for service
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the drive motor.
Shop the drive motor at RepairClinic or Amazon
Also tied to this fault: motor control board - Shop at RepairClinic or Amazon
Parts that commonly fix the F06 code
- drive motor - Shop at RepairClinic or Amazon
- motor control board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Whirlpool manual is on Whirlpool's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.