Whirlpool Washer Duet (Legacy Front-Load) F09 Error Code
What the F09 code means
Overflow condition on older Duet models: the overflow contact on the pressure switch stayed closed too long; the door stays locked and the drain pump runs constantly.
Likely causes
- Drain hose plugged or kinked
- Failed drain pump
- Water inlet valve not shutting off → Shop the water inlet valve at RepairClinic
- Failed pressure switch → Shop the pressure switch at RepairClinic
How to fix it — step by step
- Unplug the washer - the pump runs constantly until power is removed → Shop the drain pump at RepairClinic
- Check the drain hose is not plugged or kinked
- Turn off the water supply if the tub is overfilling
- If the code returns after clearing the drain, call for service
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the drain pump.
Shop the drain pump at RepairClinic or Amazon
Also tied to this fault: water inlet valve - Shop at RepairClinic or Amazon; pressure switch - Shop at RepairClinic or Amazon
Parts that commonly fix the F09 code
- drain pump - Shop at RepairClinic or Amazon
- water inlet valve - Shop at RepairClinic or Amazon
- pressure switch - Shop at RepairClinic or Amazon
Before you buy: check the drain pump first
Test: Unplug the washer, disconnect the wire connector at the pump, set the meter to the R×1 scale, and measure across the pump terminals.
A good one reads: Approximately 12.3 Ω (Whirlpool CHW9050 service manual). The value is generation-specific: Duet-era tech sheets spec 15 Ω and current Whirlpool tech sheet W11417646 specs 18.5–21.5 Ω, so confirm against your model's tech sheet.
Test values from manualslib.com documentation - confirm against your model's own tech sheet.
Before you buy: check the water inlet valve first
Test: Unplug the washer and measure each fill valve solenoid's coil resistance at the valve or at the ACU connector pins listed in the tech sheet.
A good one reads: 1100–1350 Ω per coil (Whirlpool tech sheet W11417646, Test #6). Older Duet solenoids spec 800 Ω — use the range on your model's tech sheet; open or far out of range means replace the valve assembly.
Test values from forum.appliancepartspros.com documentation - confirm against your model's own tech sheet.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Whirlpool manual is on Whirlpool's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.