Subaru SUV Outback Overheating Error Code

What the Overheating code means

Blown head gaskets are the notorious legacy problem of the Subaru EJ25 engine in older Outbacks: the gasket fails and lets coolant leak externally or into the cylinders, causing coolant loss, overheating and eventually severe engine damage. On an older Outback that overheats and loses coolant, the head gasket is the prime suspect rather than an outside possibility.

Likely causes

  1. Head gasket failure on the EJ25 engine
  2. Low coolant from radiator, hose or water pump leaks → Shop the water pump at Amazon
  3. Stuck thermostat or failed fans → Shop the thermostat at Amazon
  4. A previously overheated engine warping the head and killing the new gasket if not machined

How to fix it — step by step

  1. Stop driving if the gauge climbs; Subaru heads warp readily when overheated
  2. Check coolant level cold and look for external leaks, milky oil, or bubbles in the reservoir while running
  3. Have a shop do a pressure test and a block test for exhaust gases in the coolant to confirm the gasket
  4. A confirmed head gasket is major work; both heads should be checked and machined as needed, and the timing belt service usually makes sense at the same time → Shop the timing belt kit at Amazon

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix the Overheating code

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Subaru manual is on Subaru's support site — you'll need your model number.

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Subaru SUV Outback error codes

See all Subaru Outback codes & guides →