Subaru SUV Outback Check Engine Light On
What this problem usually means
On the 2010-2014 Outback, Samarins identifies code P2096 as a check engine pattern with several possible causes: a bad rear O2 sensor is one, but the guide stresses the car must be properly diagnosed, because a bad or dirty mass airflow sensor, a vacuum leak, a dirty throttle body, exhaust leaks, or sensor connector and wiring issues can produce the same code. At higher mileage the catalytic converter itself can fail, revealed by code P0420, and the OEM converter is expensive. On the 2013-2014 FB25 engine there are also a number of complaints about excessive oil consumption (Subaru bulletin 02-157-14R), so a low oil level is part of the picture whenever the light comes on in those years.
Likely causes
- Failed rear oxygen sensor setting code P2096 → Shop the rear oxygen sensor at Amazon
- Bad or dirty mass airflow sensor, vacuum leak or dirty throttle body producing the same lean code
- Exhaust leak, or a fault in the rear O2 sensor connector or wiring
- Catalytic converter failure at higher mileage, setting code P0420
- Low engine oil level from the FB25 engine's excessive oil consumption (2013-2014; Subaru bulletin 02-157-14R)
How to fix it — step by step
- Have the exact code read and write it down; P2096, P0420 and misfire codes lead to different parts on this model
- For P2096, diagnose before replacing: test the rear O2 sensor, and check for exhaust leaks, a dirty mass airflow sensor or throttle body, vacuum leaks, and sensor wiring faults → Shop the mass airflow sensor at Amazon
- Check the engine oil level; on a 2013-2014 FB25 a low level can indicate the documented oil consumption problem, which is measured with a consumption test rather than fixed with a sensor → Shop the engine oil at Amazon
- For P0420, confirm the catalytic converter has actually failed before replacing it - the OEM part is expensive, and an aftermarket converter fitted by a muffler shop is the cheaper route Samarins notes → Shop the catalytic converter at Amazon
- Clear the code after the repair and confirm the light stays off through a full drive cycle
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the rear oxygen sensor.
Shop the rear oxygen sensor at Amazon
Also tied to this fault: mass airflow sensor - Shop at Amazon; catalytic converter - Shop at Amazon; engine oil - Shop at Amazon
Parts that commonly fix it
- rear oxygen sensor - Shop at Amazon
- mass airflow sensor - Shop at Amazon
- catalytic converter - Shop at Amazon
- engine oil - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Subaru manual is on Subaru's support site — you'll need your model number.
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.