Subaru Hatchback Crosstrek Excessive oil consumption
What this problem usually means
The FB20 2.0-liter engine in 2013 to 2017 Crosstreks has a documented oil consumption problem tied to the oil control piston rings, covered by Subaru technical bulletin 02-157-14R for 2012 to 2015 models. Subaru extended coverage to 8 years or 100,000 miles, and its remedy for confirmed cases is replacing the short block assembly.
Likely causes
- defective oil control piston rings → Shop the oil control piston rings at Amazon
How to fix it — step by step
- Check the oil level regularly and record how much you add between changes
- Top up with the correct oil before the level reaches the low mark
- Ask a dealer to run an oil consumption test, topping off and returning after a set interval of about 1,200 miles
- Check by VIN whether the oil consumption warranty extension applies, and have the short block replaced if the test confirms excessive use
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the short block assembly.
Shop the short block assembly at Amazon
Also tied to this fault: oil control piston rings - Shop at Amazon
Parts that commonly fix it
- short block assembly - Shop at Amazon
- oil control piston rings - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Subaru manual is on Subaru's support site — you'll need your model number.
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.