Subaru Hatchback Crosstrek Brake light switch failure
What this problem usually means
A recall covering 2013 to 2017 XV Crosstrek models addresses a brake light switch that can lose electrical conductivity from silicone residue left by common consumer products. When the switch fails the brake lights may not illuminate, cruise control may not disengage when braking, and the shifter may not release from Park.
Likely causes
- silicone residue on brake light switch contacts
How to fix it — step by step
- Stop and check whether the brake lights illuminate when a helper presses the pedal, and avoid driving if they do not work
- Note any cruise control that fails to cancel or a shifter stuck in Park, which can point to the same switch
- Check by VIN whether recall 19V-149 applies to your Crosstrek
- Have a dealer replace the brake light switch free of charge under the recall → Shop the brake light switch at Amazon
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the brake light switch.
Parts that commonly fix it
- brake light switch - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Subaru manual is on Subaru's support site — you'll need your model number.
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.