Shark Robot vacuum IQ / EZ Series CLEAN (RED) + DOCK (BLUE) flashing
What this problem usually means
Error number 7 in Shark IQ and EZ manuals: cliff sensor error. Shown by CLEAN red and DOCK blue flashing. AI Robot models show the same Error 7 with DOCK white instead of blue — see the AI Robot Series entry.
Likely causes
- Cliff sensors dirty or dusty
- Robot too close to stairs or an edge
- Dark flooring triggering the cliff sensors
How to fix it — step by step
- Move the robot to a new location away from stairs and edges
- Wipe the cliff sensors on the underside with a clean, dry cloth
- Place the robot on a level floor
- Restart cleaning
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Shark manual is on Shark's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.