Shark Robot vacuum IQ / EZ Series CLEAN (BLUE) + ! (RED) flashing
What this problem usually means
Error number 2 in Shark IQ and EZ manuals: blockage in the brushroll. Shown by CLEAN blue and ! red flashing. (Both families also list a second brushroll pattern, CLEAN (RED) + ! (RED) alternating, with the same solution; AI Robot models show the brushroll blockage with white/alternating patterns instead — see the AI Robot Series entry.)
Likely causes
- Hair, string or carpet fibres wrapped around the brushroll
- Object jammed in the brushroll housing
- Brushroll end caps clogged with debris
How to fix it — step by step
- Turn the robot off and turn it over
- Remove the brushroll and pull off all hair and debris from around and inside it
- Clear the brushroll housing and end caps, then refit the brushroll
- Restart cleaning
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Shark manual is on Shark's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.