Shark Robot vacuum IQ / EZ Series CLEAN (BLUE) + DOCK (RED) solid
What this problem usually means
Error number 14 in Shark IQ and EZ manuals: BotBoundary error. The robot is on or too close to a BotBoundary magnetic boundary strip. The AI Robot (RV2500/AV2501-series) chart has no Error 14 row — those models use app no-go zones instead of magnetic strips.
Likely causes
- Robot started on top of a BotBoundary strip
- Robot too close to the magnetic boundary strip to navigate away
- Boundary strips set up incorrectly
How to fix it — step by step
- Pick the robot up off the boundary strip
- Move it to a flat surface well away from the magnetic boundary strip
- Check the boundary strips are laid out correctly
- Try cleaning again
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Shark manual is on Shark's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.