RAM Truck 3500 Hydraulic lifter failure on 2019+ Cummins
What this problem usually means
For 2019 the 6.7L Cummins in the Ram 2500 and 3500 switched from the tappet design used since 1989 to hydraulic lifters, and some engines develop a lifter tick inside the first 10,000 miles — a rapid tap that does not fade at operating temperature. Left unaddressed, a failed lifter can destroy the camshaft, and circulating debris can lead to engine replacement.
Likely causes
- premature hydraulic lifter failure
- camshaft damage from a failed lifter
How to fix it — step by step
- Listen on a cold start for a rapid tapping that does not fade as the engine warms up
- Stop driving and arrange inspection if the tick gets louder or the check engine light comes on
- Have a diesel shop verify the lifter noise is valvetrain-related and check for camshaft damage → Shop the camshaft at Amazon
- Have the failed lifters and any damaged camshaft replaced by a shop
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the hydraulic lifters.
Shop the hydraulic lifters at Amazon
Also tied to this fault: camshaft - Shop at Amazon
Parts that commonly fix it
- hydraulic lifters - Shop at Amazon
- camshaft - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.