RAM Truck 3500 EGR and DPF clogging causing limp mode
What this problem usually means
On 6.7L Cummins Ram 3500 trucks from 2007.5 onward, the EGR, diesel particulate filter and SCR/DEF emissions systems can clog with soot, especially when the truck is not driven long enough at highway speed to complete a regeneration cycle. Signs include poor fuel economy, constant 'DPF Full' messages, loss of power and check engine lights, and in severe cases the truck enters limp mode.
Likely causes
- soot clogging of the diesel particulate filter → Shop the diesel particulate filter at Amazon
- soot build-up in the egr system from short trips and idling
How to fix it — step by step
- Drive the truck at sustained highway speed to let a regeneration cycle complete if a DPF message appears
- Note how often 'DPF Full' messages appear and whether power is reduced
- Have a diesel shop run a forced regeneration and test the EGR and DPF before condemning parts
- Have a clogged EGR cooler or DPF cleaned or replaced if forced regeneration does not clear it → Shop the egr cooler at Amazon
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the diesel particulate filter.
Shop the diesel particulate filter at Amazon
Also tied to this fault: egr cooler - Shop at Amazon
Parts that commonly fix it
- diesel particulate filter - Shop at Amazon
- egr cooler - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.