RAM Truck 3500 CP4.2 high-pressure fuel pump failure

What this problem usually means

The Bosch CP4.2 high-pressure fuel pump fitted to 2019 and 2020 Ram 3500 trucks with the 6.7L Cummins is prone to self-destruction, sending metal shavings through the entire fuel system and contaminating the injectors, lines and tank. There are often no warning signs before the truck suddenly loses power, goes into limp mode or fails to start, and Ram switched back to a CP3 pump for later models.

Likely causes

  1. cp4.2 high-pressure fuel pump self-destruction → Shop the high-pressure fuel pump at Amazon
  2. metal contamination of the fuel system

How to fix it — step by step

  1. Stop driving if the truck loses power or will not restart — continued running spreads metal debris
  2. Check by VIN whether the fuel pump recall applies and whether it was completed
  3. Have a diesel shop inspect the fuel system for metal contamination before replacing parts one at a time
  4. Have the full contaminated fuel system repaired — pump, injectors, rails and lines, with the tank dropped and cleaned → Shop the fuel injectors at Amazon → Shop the fuel rails at Amazon

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related RAM Truck 3500 problems

See all RAM 3500 codes & guides →