Payne Furnace 34.2 Error Code

What the 34.2 code means

Flame lost after successful ignition on the Payne PG80MSU (3-digit display model). The LED flashes major code 34 while the display reads 34.2: flame was proved, then lost before the heating blower on-delay.

Likely causes

  1. Oxide buildup on the flame sensor
  2. Low inlet gas pressure
  3. Gas valve defective or turned off
  4. Poor control ground continuity
  5. Inadequate flame carryover or rough ignition

How to fix it — step by step

  1. Confirm other gas appliances in the house are working normally
  2. Check that the air filter is clean and vents are open
  3. Do not attempt to clean or reposition the flame sensor yourself
  4. Call a technician - flame loss right after ignition is a combustion and flame-sensing fault

Parts that commonly fix the 34.2 code

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Related Payne furnace error codes

See all Payne furnace codes & guides →