Payne Furnace Rapid flashing
What this problem usually means
On Payne furnaces such as the PG92ESA, PG95ESA and PG96VTA, an amber status LED blinking rapidly with no pause means the line-voltage (115 V) polarity is reversed at the furnace (on twinned units, check 24 V transformer phasing). The control cannot prove flame, so the furnace will not run.
Likely causes
- Hot and neutral wires reversed at the furnace, a junction box or an outlet
- Improper 24 V transformer phasing on twinned furnaces
How to fix it — step by step
- Note the flash pattern before turning anything off, so you can tell the technician
- Turn the furnace off at the service switch and leave it off
- Do not open junction boxes or swap wires yourself - this is live 115 V wiring
- Call an HVAC technician or electrician to correct the reversed polarity
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.