Payne Furnace 13 Error Code

What the 13 code means

Limit circuit lockout. On Payne furnaces such as the PG92ESA, PG95ESA and PG96VTA, code 13 occurs when the limit or flame rollout switch stays open longer than 3 minutes. The control locks out and auto-resets after 3 hours; see code 33 for the underlying fault.

Likely causes

  1. Repeated overheating from a dirty filter or restricted duct system
  2. Restricted vent or improper vent sizing
  3. Blower motor not functioning
  4. Flame rollout switch tripped

How to fix it — step by step

  1. Turn the thermostat down and let the furnace cool completely
  2. Check the air filter and replace it if dirty
  3. Open all supply registers and make sure return grilles are not blocked
  4. Wait for the 3-hour auto-reset or cycle power once at the service switch
  5. If 13 returns, stop resetting and call a technician - a tripped rollout switch must be diagnosed, never just reset

Parts that commonly fix the 13 code

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Related Payne furnace error codes

See all Payne furnace codes & guides →