Payne Furnace 42 Error Code
What the 42 code means
Inducer RPM fault on the Payne PG80MSU (80% furnace with 3-digit display and pressure transducer). Minor code 42.1 means no RPM feedback at start-up or before ignition proved, 42.2 means the RPM signal was lost for 5 seconds after ignition proved, and 42.3 means the inducer is exceeding its model-specific RPM limit.
Likely causes
- Failed inducer motor
- Improper vent sizing
- Restricted combustion air supply
- Loose or damaged inducer motor wiring
How to fix it — step by step
- Check the outdoor intake and exhaust pipes for snow, ice, leaves or a nest blocking them
- Note the code for the technician
- Cycle power once at the service switch
- If 42 returns, call a technician - a furnace that cannot run its inducer cannot vent combustion gases safely
Parts that commonly fix the 42 code
- inducer motor - Shop at RepairClinic
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.