Payne Furnace 26.1 Error Code
What the 26.1 code means
Loose factory wiring on Payne furnaces with a 3-digit status display. The LED flashes major code 26 while the display reads 26.1: a jumper in the factory wiring harness is loose or disconnected.
Likely causes
- Jumper in the factory wiring harness is loose
- Jumper in the factory wiring harness is disconnected
How to fix it — step by step
- Note the code for the technician
- Do not open the control compartment to reseat harness jumpers yourself
- Turn the furnace off at the service switch if it will not run
- Call a technician to inspect and reseat the factory wiring harness
Parts that commonly fix the 26.1 code
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.