Narwal Robot vacuum Narwal Freo X Ultra Map not saved after mapping
What this problem usually means
The map is not saved after the robot finishes building it.
Likely causes
- Robot was manually moved back into the base station before mapping completed
- Mapping task was forcibly ended early
How to fix it — step by step
- Let the robot scan the home and return to the base station on its own - the map is saved only after the robot broadcasts that mapping is completed.
- Do not manually move the robot back into the base station or force the mapping task to end before that broadcast.
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.