Narwal Robot vacuum Narwal Freo X Ultra Map created is incomplete
What this problem usually means
The map the robot created is incomplete - some rooms/areas are missing.
Likely causes
- Room door not fully open, or objects at the door blocked laser scanning
- A person or pet walked around / followed the robot during scanning
How to fix it — step by step
- Try mapping again.
- Before mapping, put away wires, toys and other floor obstacles, open the doors of rooms to be cleaned and close the rest.
- Do not follow or walk around the robot during mapping; let it return to the base station on its own.
- If a room was skipped, pause the task, push the robot into the room (keeping it on the floor) and press Start to resume.
- If the map is still incomplete after multiple attempts, contact after-sales service.
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.