Narwal Robot vacuum Narwal Freo X Plus Map not saved
What this problem usually means
The map created by the robot is not saved.
Likely causes
- Mapping task was ended early
- Robot was manually moved back to the base station before mapping finished
How to fix it — step by step
- Let the robot complete the map scanning and return to the base station on its own - the map is only saved after the voice prompt indicating map completion.
- Do not manually move the robot back to the base station or forcibly end the mapping task.
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.