Narwal Robot vacuum Narwal Freo X Plus App shows robot offline
What this problem usually means
The app shows the Freo X Plus as offline and it cannot be controlled.
Likely causes
- Robot is not turned on
- Robot not aligned with the charging contacts in the base station, so the battery ran out
- Robot temporarily out of range of the base station during a task
- Communication failure between base station and robot
- Home network problem
How to fix it — step by step
- Turn the robot on: press and hold the Start button on the robot for 2 seconds until the indicator is constant white.
- Put the robot in the base station with the side brushes facing outward and align it with the charging contacts.
- If it went missing mid-task far from the base station, wait for the base station to reconnect - the robot keeps working normally.
- Reboot the base station: unplug the power cord, wait 30 seconds after the indicator goes out, then plug it back in.
- Check the home network, restart the router, and try reconfiguring the network.
- If the issue persists, contact Narwal customer service.
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.