Mazda Sedan Mazda6 Parking Brake Actuator Corrodes And Binds
What this problem usually means
Water can get into the rear brake caliper on 2014-2015 Mazda6s and corrode the parking brake actuator shaft, so the parking brake may bind or fail to release; the CarWhere summary of NHTSA safety recall 17V393 puts the combined Mazda3 and Mazda6 population at 227,814 vehicles. Dealers check the shafts and replace corroded ones free of charge.
Likely causes
- Water entry into the rear brake caliper
- Corrosion of the parking brake actuator shaft → Shop the parking brake actuator shaft at Amazon
- Parking brake dragging or failing to release as corrosion progresses
How to fix it — step by step
- Check your VIN at nhtsa.gov/recalls for 17V393 and have the shafts inspected under the recall
- Watch for a parking brake that drags, or a rear wheel that runs hot after a drive
- Do not keep driving with a dragging rear brake; it overheats the caliper and rotor → Shop the rear brake caliper at Amazon
- Confirm the recall shows complete for your VIN after inspection or replacement
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the parking brake actuator shaft.
Shop the parking brake actuator shaft at Amazon
Also tied to this fault: rear brake caliper - Shop at Amazon
Parts that commonly fix it
- parking brake actuator shaft - Shop at Amazon
- rear brake caliper - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.