Mazda Sedan Mazda6 Engine Stalls While Driving

What this problem usually means

Certain 2018-2019 Mazda6s with the cylinder-deactivation engine are under Mazda recall 3719F, NHTSA 19V497: loss of engine power and/or an engine stall may occur due to inappropriate programming of the hydraulic valve clearance adjuster software which controls cylinder deactivation and reactivation. Mazda's dealer notice, hosted on NHTSA's site, titles 3719F a Safety and Emissions Recall affecting 304,882 vehicles across the CX-5, Mazda3 and Mazda6, and the remedy is a software reprogram with no parts replaced.

Likely causes

  1. Powertrain control module software error in cylinder-deactivation HLA control
  2. Valve clearance adjuster behaving incorrectly during deactivation changeover
  3. Stall under the specific driving conditions the faulty programming allows

How to fix it — step by step

  1. Check your VIN at nhtsa.gov/recalls for 19V497; the reprogram is free at a Mazda dealer
  2. Do not chase fuel or ignition parts for a stall on an affected car until the recall status is known
  3. If it stalls repeatedly, stop driving it until the recall is done rather than relying on restarts
  4. Confirm the recall shows complete for your VIN after the dealer visit

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Mazda Sedan Mazda6 problems

See all Mazda Mazda6 codes & guides →