Mazda Sedan Mazda6 CV joint clunking noise
What this problem usually means
A bad CV joint on the Mazda6 shows up as clunking and popping noises, and the vehicle can also shudder or shake. The joint is protected by a rubber boot; once the boot cracks or is damaged, contaminants get in and wear the joint prematurely. Most mechanics advise replacing the worn CV joint rather than repairing it unless a damaged boot is caught early and the joint is still sound.
Likely causes
- worn cv joint
- cracked cv boot letting contaminants into the joint
How to fix it — step by step
- Listen for clunking or popping from the front and note any shudder or shaking
- Inspect the CV boots for cracks or slung grease if they are safely visible
- Have a shop confirm joint wear and check whether the boot alone was caught in time
- Replace the worn CV joint or drive shaft assembly
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the cv axle.
Also tied to this fault: cv boot kit - Shop at Amazon
Parts that commonly fix it
- cv axle - Shop at Amazon
- cv boot kit - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.