Mazda Sedan Mazda6 Engine Ticking Noise

What this problem usually means

A loud ticking noise — hydraulic valve lifter (valve lash adjuster) noise — may be heard from the top of the Mazda6 engine, particularly when the engine is cold or oil changes have been infrequent, per RepairPal. Sludged or aerated oil and worn lash adjusters both produce the tick, so oil condition is part of the diagnosis, not an afterthought.

Likely causes

  1. Hydraulic valve lash adjusters ticking from wear or oil starvation
  2. Infrequent oil changes leaving sludge that restricts adjuster oil feed
  3. Low oil level or wrong oil viscosity
  4. Exhaust manifold leak ticking, which must be ruled out

How to fix it — step by step

  1. Check the oil level and condition first and change overdue oil and filter before condemning parts
  2. Note when it ticks: cold-only ticking that fades warm differs from a persistent tick under load
  3. Rule out an exhaust manifold leak, which ticks loudly cold and often quiets as it warms and expands
  4. Replace the affected valve lash adjusters if the tick persists with clean oil at the correct level → Shop the valve lash adjusters at Amazon

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Mazda Sedan Mazda6 problems

See all Mazda Mazda6 codes & guides →